Evo Start 2 not working with Evo one with T Harness Thar one Maz3

Question

Hello,

I recently bought Evo start 2 for my Evo one which I have been using for more than 2 years on my Mazda cx 3 2019 with T harness. At that time I did not choose the app start option while programming the Evo one. Can some please help me where should i be connecting the Yellow wire. Does it goes into the A1. Also none of the other options like door unlock are not working. Do I have to reprogram the Evo one again. I know that the firmware should be atleast 1.21. When i push start from the app the green light on the evo start 2 is turning on but nothing is happening.

I have followed the following steps and it was not working.

Ignition ON - OFF - ON (While holding the brake?)

Press and release brake 4 times

Press and hold the Evo start button until green

Turn OFF Ignition

Thank you for reading any kind of help or suggestions is much appreciated 

Answer 1

Hello,

The yellow wire from the antenna needs to be connected to ignition.

Once that is done re program it. Do not hold the brake while doing ign on-off-on.

Make sure the evo start2 is plugged into the small blue port on the evo-one.

Best regards.

Comments

Hello Derek G,

Firstly thank you so much for replying.

I have connected the yellow cable from evo start 2 and the yellow cable thats going into the Evo one T harness which connected to A1 port.

Evo start2 is plugged into the blue port 4 pin.

Next do I have to press the igintion button without holding the brake. This means only the car will turn on but not the engine. Please confirm, thank you.

---

do not touch the brake when turning on or off the ignition.

---

Thank you.

I will give it a try. Currently the yellow cable is connected to the yellow cable of 20 pin connector, A1. If this does not work i will tap into the pink cable E5.