Chrysler Pacifica & int-sl+ problem

Question

Hello!

 I have a few questions about installing int-sl+ in Chrysler Pacifica 2004.

 1. Should I do step 5 when programming if I don't use data link? (hardwire connection)

2. What does the note "Can be proggrammed 5 times max." mean in the instructions (at step 7) and what happens after more 5 attempts on the same machine?

3. In programming process on step 7 the LED flash a few times and turn off. I think the interface is programming. The engine is running by remote start, but stopping after 1-2 seconds. The immobilizer LED flashes, indicating that the key is missing. The diode on the INT-SL+ is constantly off at startup. If i put the key near barrel, the engine running correctly without stopping. What do i incorrectly ?

Answer 1

Hello,

 

Sounds like the int-sl+ is not being activated by your remote starter if the red led does not turn on when remote starting.

If that is the case then you would want to verify the operation of the ground while running from the remote starter to the int-sl+.

Best regards.