I cannot get through step 5 to 6. On the blue light is solid and I press the program button the light just turns off.

When working on steps five through six I get the solid blue light I press the ignition button twice then the program button and the light turns off and does not come back on. This is on a 2013 Dodge Journey push to start.

asked May 14, 2020 in Dodge by Michael jones2 (130 points)

1 Answer

If blue led turn off but does not flash means the module does not see can bus. Verify canbus connections.

answered May 17, 2020 by Mathieu Bertrand Collin2 (62,060 points)

can you use the can wires on the OBD2 port?

commented Dec 13, 2020 by Kelly Chartrand (100 points)

Questions & Answers

I cannot get through step 5 to 6. On the blue light is solid and I press the program button the light just turns off.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Questions & Answers

I cannot get through step 5 to 6. On the blue light is solid and I press the program button the light just turns off.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions