Hello, I am struggling to get my Evo-One remote-start working. When i connect it to the car and connect all of the cables I either get no lights at all or I get the red led in the manual/automatic cable slot. I am using install guide 78101 since I have an alarmed 2005 Nissan Xterra.
Then when I try lock lock lock with my OEM fob I get nothing, no dash lights / ignition either. No LED's on the evo. If I try it with the key ignition I also get nothing.
So, I kept on running the programming and decryptor assuming this was the reason the remote start would not work. Now I have exceed the decryptor limit so I need this resetting please.
SN002b04 009600
But this is a side issue. I will try connecting it all again when I get the reset but right now I am thinking the result will be the same.
Can you clarify what happens when you enter the blue LED programming mode. Does the evo-one check all of the connections when you turn the key on? Assuming this was the case this is why I kept reprogramming because in between I was checking connections for integrity.
The specific Nissan Xterra guide doesn't say anything about programming the OEM fob. Have I missed this step?
I can confirm that oem 3x lock has been enabled in both the bypass and remote start and the correct settings have been selected in the software as shown on the Xterra specific instructions. I had missed one of the settings which dictated the ignition wire combinations but this has now been corrected to match how I have wired those cables.
One other thing I have noticed is that I was reading the instruction wrong about the order in which you disconnect the cables during programming. Would this have a big effect?
Thanks in advance for any help.
