Evo all not flashing blue on step 10

Question

When going through the installation process the Evo all does not flash blue on step 10. All wires are connected with the exception of the hood wire. I have tried firmware 74.32 like the guide suggests as well as 74.18 like the flashlinj suggests.

Answer 1

At this step the only thing the module is looking for is the canbus wire.

Make sure they are connected correctly and also make sure vehicle is not a 2019.

Comments

After checking and making sure the canbus wires were tightly connected now the evo-all blue light turns off but does not flash just comes back on once ignition is turned off. Upon attempting to use the decryptor it goes through but when I connect the Evo all back to car all 3 lights flash. It's a 2018 Journey.

---

Same issue here with a 2016 Dodge Journey. Please advise.