Which Wire to connect to on back of push button 2016 Nissan Juke

Question

I was able to wire everything else just fine in my 2016 Nissan Juke except I want to make sure the push button wire that I connect the black/white pin A19 to on the fortin evo all is correct. I believe it is the light green wire that is 12v when not pressed and 0v when button is pressed. However the guide is confusing and I am not sure if it is saying if I should test to make sure the wire I am connecting too is 12v when not pressed and 0v when not pressed or if is saying not to connect to that wire. The diagram shows that pin A19 is push to start negative but its seems weird to me that a negative wire has 12v when not pressed and 0v when pressed. I am following the standalone guide with the tharness # 32791.

 

Evo-all Hardware Rev 6 Firmware V72-29

Answer 1

Yes this is the correct wire.

Comments

Thank you so much it appears to work with no issue.