Hazard lights flashing intermittently

Question

Unit is installed and starts the car. When driving the hazard lights will begin flashing intermittently. Is there a possibility that a circuit is being completed by wires touching?

Answer 1

Yes it is a possibility but the hazards wires are not used by the remote starter. Verify every harness where you have connected wires to make sure you didn't hurt other wires.

Comments

I pulled it out again and looked at everything. All the wires look fine. Could it be that the yellow ignition wire wasnt secure enough?

 

I drove the car, the doors would unlock and the hazards would flash a few times. Then turn off again. It would seem it would happen at low speeds, while braking or coming off a stop.

Thanks for the help

---

What is the service number on the module ? Is the vehicle manual transmission ?

---

Sorry for the late reply

 

The jeep is automatic.

 

Service number on the module is: 001A06 747906

---

Bumping this comment back up

---

Hi -

 

Not sure if I should start a new thread to get this going again. Or if my replies weren't notifying because I was answering my own comment.

 

Thanks for the help - Not sure if I should return the product or not at this point

---

The EVOALL does not have the capability to turn on the hazard lights.... Might just be another problem with the vehicle

---

Adam- did you find any solution on this?  This is currently happening to me as well- 2015 Jeep Wrangler randomly unlocks doors and flashes hazards while driving.  Thanks for any info!