During programming of evo-all, No Red Blinking after ignition on - only blue light blinking

Question

all connections double checked including light blue/black to key data(ems com). i did cut the wire to see if engine will not start-and it did not start after cutting. that confirmed im on the correct wire.

Answer 1

Cutting the wire does not mean you are on the right wire, you could cut hundreds of wires in a vehicle and it would not start.

When you let go on red how many times do you push the programming button and how many times does the red led flash afterwards?

Comments

i cut only 1 wire (data key/ems com) to confirm im on the correct wire, then tap there the l.blue/black wire.. seven times pushed with six blinking red lights at the end.. then ign ON, there is about 8 blinks on the red then continous blink on the blue.. ign OFF..

no simultaneous red/blue blinking after ign ON

---

sounds to me like the module programmed. Guide says itll flash red, then flash blue afterwards...which is exactly what you just decribed.

 

http://cdn.fortin.ca/download/34351/evo-allv2_hyundaisantafe2013_pts_revb-20150702-2.pdf

---

correct, i did programed the evo-all correctly.. i had the problem with the remote start module programming.. its perfectly working now.. thanks and more power

p.s. hope someday you invent a module that will make a car drive for itself, like an auto pilot ????