Linkr LT1 not pairing with EVO All

Question

My Linkr LT1 module does not pair with the evo-all. I am able to get into the programming mode and the lights on my Linkr LT1 are solid, but I never get a blink or acknowledgement that the Linker LT1 was programmed to the evo. I've also tried this process after disconnecting them for a long while with no luck as well. Please refer to the video which shows my failed attempt. My veichle is a 2021 Audi Q5.

https://youtu.be/4yhramq7ll0

Answer 1

Hello,

 

Ensure that the app is set to fortin protocol and that  options H & H2 has been enabled in the evo-all module prior to attempting the in vehicle programming of the linkR. .

 

If it still does not program I would look at the adapter that has been used. LLRS-01.

 

Best regards.

Comments

The app was actually set to ADS protocol, I changed it and said it to Fortin with no luck. I also insured that the H & H2 two options are enabled in the evo all module. The adapter I am using is also the correct one. Are there any other troubleshooting steps I can take?

---

At the step in the programming were it says to turn ignition on, try sending lock from the app at that point.

 

If it programs the red and blue led's on the evo-all should blink 1x indicating it received a signal from the linkR module.