Installed but wont remote start

Question

2011 Ford Taurus Standard Key. I installed the Evo-Fort4 system and T harness included. I was able to successfully program my one key, run it through dcryptor, and when I plug it back into the car, it doesnt seem to do anything. I have D1.1 for lock unlock lock turned on, and A11 off because my car doesnt come equipped with a hood latch sensor. I have been through the forums a lot and can't figure out what might be the issue. When I lock-unlock-lock the evo doesnt light up at all either. Thanks      

Edit: I also used guide #95201 if that helps. Thanks

Answer 1

What is the S/N number on the back of the module please.

Comments

001A07 219932

---

If you start the vehicle noramlly with the key, what light turns on on the evo?

---

No lights turn on

---

That would tell me the 1 key dcryptor programming did not work properly.

 

Re program the module in the vehicle and re run the dcryptor.

 

When the evo is programmed the yellow light will turn on when ignition is on.