red flashing instead of red and yellow flashing?

Question

Mazda cx-5 2018

 

Evo all guide # 66311

 

on step 13 I have an only red light flashing once every second and did not stop!!

 

I tried and read different solution founded here, but it ends with the same red flashing

 

all wires connected correctly 

Answer 1

I responded to your email with the steps you need to take to try and correct the issue.

Comments

I am having the same issue

---

Can you please send me these instructions as well!

---

please end me an email for instruction. im stucking here as well

---

I am having the same issue Mazda 3 2015. On step 13 I have only red light flashing. DCryptor says INVALID KEY DATA and "The immobilizer data received by the bypass module is incomplete. Please try again. If this error persists reconnect the module to the vehicle and start programming procedure from STEP 1."
System was working before. Problem hapened after firware update to version 85.09
Could you please give me instructions. Thank you

---

I responded to the email you sent Leanid.

---

i am having the same issue could i get steps as well thanks

---

Hello,

Looking at the history of the module it shows you dcrypted it once already on the 12th. You cannot re program the module a 2nd time.

Try flashing firmware 71.47 and re attempt programming. If it does not work you will need to try a new evo-all.

Best regards.