EvoAll 2019 Toyota Rav 4 FWD Push to start not starting engine

Question

EvoAll Regular installation without takeover. GUIDE # 83841

Programmed Flash-Link4 with latest firmware, and EvoAll updated to latest version as well.

As a first time installer, I've installed this to the best of my abilities. Here are the EXACT steps that i took;

1- (-)start/stop TO EvoAll A19

2- (-)lock TO EvoAll A20

3- (-)unlock TO EvoAll A10

4- EvoAll B4 TO (+)12V ***I didnt, but must I install a 7.5 Amp fuse???***

5- EvoAll B3 TO Ground

6- EvoAll A1 TO (+)Ignition ***I didn't but must I install a 1A Didode???***

7- (-) Steering Lock TO EvoAll D6

8- (~)Can High TO C3

9- (~)Can Low TO C4

After programming the EvoAll, 3xLock will turn on the ignition, then turn off, and make a second attempt to turn on, then  off again with no engine crank at all.

AM I MISSING SOMETHING(S)???

Answer 1

D5 goes to ground

Comments

please send me your email address so i can gift you a $20 amazon gift card!
Thankyou Matthieu!!