Questions & Answers

2015 toyota sienna h-key

0 votes
service # 002b05027867

 

Installed but will not remote start. Doesnt attempt to crank. Is not in valet mode. Yellow loop is cut. Wiring and programing look to be correct. Have both lock and unlock signals on evo when button is pressed on remote as well. What am i missing? According to the install guide 3x lock should work...
posté Sept 3, 2018 dans la catégorie Toyota par Lastminuteracin (650 points)
modifié Sept 4, 2018 par Lastminuteracin

1 Réponse

+1 vote
Does the ignition turn on ?
répondu Sept 4, 2018 par Mathieu Bertrand Collin (62,040 points)
No it does not. Forgot to add this is a tee harness installation
Did you connect ground ?

When pressing 3x lock, the red led on the side of the module right under the yellow loop should flash a certain amount of times. How many flash you see ?
Yes to a factory ground. The hood pin switch is also grounded to eliminate that.  I’ll have to look at that led and get back to you. You can hear the relays inside the box click just no output to the vehicle to crank it.
I have a video of it. Hard to get an accurate count but appears to be 5?. You have to hit lock way more than 3x for it to do anything.
You hood pin is grounded. It should not be. Ground = hood open therefore remote starter will not remote start

 

Also, Lock press every second. or set Lock-Unlock-Lock instead of 3x Lock. (option 38.5)
Thanks I’ll try disconnecting it later today. Hopefully that does the trick.
That was it! Thanks. Not sure what I was thinking. I normally don’t even use it
Factory hood pins are normally ground when closed. Aftermarket is the opposite. :D
...