No key detected after decryptor

Question

2013 mks PTS evoall hardwired to viper4806

Evoall programmed successfully and decryptor used  when remote starting red light and then yellow red come on evoall

Brake lights come on and interior lights come on  then message of No Key Detected and alarm goes off

SN  001A07 150161

71.52 loaded

Answer 1

Hello,

I would take a look at your Tx connection, if it is on the wrong side of the cut the module will program from a-z but not remote start since the data is going to the wrong location in the vehicle.

Best regards

Comments

Pulled out ohmmeter to check connections and they are correct

checked can bus wiring and push to start wire and correct

OEM remote starter working fine.

tried activating 3x lock as standalone and it doesn't do anything (I don't think remote start sequence started)

does running decryptor again increase key count in car?

---

No it does not.

I would suggest then at this point to phone into the support line so an agent can go over it with you. Be sure to have the module, flasher and vehicle on hand when calling in.

1-877-336-7797

Mon - Fri

8am 6pm est

Best regards

---

Called and spoke to Robert thank you

We loaded version 0.57 and remote start worked.

went back to connecting viper 4806

Remote locks do not work (don't think 0.57 supports locks)

Radio stays on when I turn off remote start.

Do locks need to be hardwired? (any changes to door pin wire that was cut?)

Will trunk release work?

---

Glad to hear Robert got it going for you!

Yes in that case simply hardwire the door locks from the viper to the vehicle. You may also need to hardwire trunk release if it is not working through data.

Best regards