car starter won't start

Question

I just finished installing a evo-all on my 2021 Chevy spark. Programming went good and dcryptor said it was done. But when I plug it back in I get no lights or response when locking my car 3 times. I only get a yellow when turning on the ignition.

Answer 1

Did you notice if any lights were flashing on the moudle after reconnecting it the car once the Dcryptor was done?

Try programming just the CAN-BUS like mentionned in your other post then just try the starter. You dont need to run dcryptor after wards. Program CAN-BUS, then simply try the starter. 

1. hold button in while inserting the power
2. release when the LED is BLUE
3. Turn Key ON
4. blue LED will flash (let it flash about 10 seconds)
5. turn key off
6. try 3xlock

Comments

note... if you are using a T-taps or any style plastic connector for that CAN-SW connection, please do a proper splice connection.

---

Full reset solved my problem thanks