No crank when using remote start or using the key to start car

Question

I updated the Evo one module to the current firmware and went ahead and re program process,during re programming process where I release programming button  when blue/red led them plug in the rest of connector then 6x press programming button then red/blue blinks 5x when I try to start car it does not crank at all.

also it does not let me do the dcryptor it says it has reach maximum limit.

now I can't even start the car with the key,no crank at all.please I really need help,thank you.

Answer 1

What is the vehicle?

 

What is the service number to the module?

 

Did you wire in any interrupts into any circuits for the isntallation?

Comments

It's 2017 Subaru Legacy(standard key)no I did not wire any interrupt that I know of.

service #002807-121019

---

"no I did not wire any interrupt that I know of."

- There are 3 interupts required in this installation. IMO, Data Door Lock, Security LED. 

https://fortin.ca/download/82741/evo-one_ig_thr_bi_sub1-legacy_2015_key_a_82741.pdf

 

This means when you try to start with the key, all connectors must be plugged into the unit.

 

Also, If you unplug the t-harness and return the stock connector does it start with the key?

 

 

---

It's 2017 Subaru Legacy(standard key)no I did not wire any interrupt that I know of.

service #002807-121019

 

sorry yes those interrupts you mention is connected

also I do not have T-harness anymore for almost a year already,it's hard wire.

and yes all connectors are plug in when I tried to start the car after red/blue led blinks 5x but it doesn't crank.

---

Start checking fuses, connectors and connections then...

---

1) I checked all fuses,connections,and I even re-did all wire connections and stil having issues after remote start 4flahses(no tach detected).

2) when programming module on step 2 after connecting all connectors and press programming button 6x. The problem is the second time I press the programming button the blue/red led would start to flash rapidly, it would not let me finish pressing the programming button 6x and would not let me start the car.

3)when I remove the module from vehicle I still can't start the car(No crank)with the key,but when disconnected all wires and connect all wires back to original the car starts fine,then I re-installed the Evo one but same problem like on 1&2 above,please I really need this resolved thank you in  advance.