2009 toyota camry remote starter engine cranks but won't start.

Question

Hello I recently ran into an issue where when I try to remote start the car,  the engine cranks but won't start and my evo one won't master reset either and I really need help to get it fixed please. And my oem key doesn't unlock/lock the car or start the car either.

The S/N is 002B04 327767

Answer 1

Hello,

 

You need to enable option 2.3 in the remote starter.

Also remote start from the factory remote is not listed as a supported option for this vehicle.

https://fortin.ca/en/vehicles/toyota/camry/2009-standard-key/

 

Best regards.

Comments

Hello I enabled option 2.3 and the engine still cranks but won't start when I use the remote starter! I don't know what's going on and bypass module won't even master reset! I checked the 20 pins plug and I noticed that the brake pin is bent, could that be the reason why the car won't start with the remote starter? And how do I fix it?

---

There should be no bent pins on the evo, this could cause a multitude of issues if the pin touches another pin on the unit.

 

What happens when you try to master reset the bypass?

---

The bypass won't master reset at all. I tried several several times by holding the programming button on the module until the red led comes on then press and holding it again but the red stays on

---

Do you know what I should do?

---

I would suggest calling into tehcnical support when you have the module, flasher and vehicle on hand so a technician can go through it with you to determine why it wont master reset and see if its the unit itself in question.

 

1-877-336-7797

mon - fri

830-530

---

I bought another bypass module but the remote starter will won't start the vehicle and I programmed it correctly! I don't know what's going on :(