Questions & Answers

Yellow LED doesn't turn on when start/stop button pressed

0 votes

EVO ALL with THAR-MAZ1  T-harness, All the connections were made however was stuck at STEP 5, The blue LED was on solid then I tapped my key onto the start/stop button nothing happened. started from STEP 1 a few times but still didn't work. Tried different key position and took battery out still nothing. Newest Firmware version.

asked Aug 8, 2020 in Mazda by Sicheng Liu (130 points)

1 Answer

0 votes

The EVO-ONE + THAR-ONE-MAZ3 would be a much easier solution to program than that the EVO-MAZT1.

EVO-MAZT1 programs and adds itself to the car as a factory remote starter. The programming for this invloves 40 steps. This solution is also only functional on North America vehicles.

 

That said.

  1. Take the batteries out the remotes
  2. Ensure the vehicle can be started wth both keys (without the batteries inside the remotes)
  3. Close/open the door
  4. Begin programming. Do not wait too long after step 4 to continue on to step 5.
answered Aug 10, 2020 by Robert T (297,620 points)
...