Questions & Answers

2011 ford F150 (evo-for1) can't program module cont.

0 votes

 

001A06 726984

 

Further to my other post, http://fortin.ca/en/qa/82485/2011-ford-f150-evo-fort1-cant-programing-unit

I have tried to do what Robb suggested.  I’ve followed all the steps (red connector [D] NOT plug in) , however I was able to make it to step 8 (a) when  Blue & Red Led flashed 10X, Wait, wait , and wait FOREVER, NO Blue LED flash.  (HOW LONG SHOULD IT TAKE for the module to switch to flashing blue?)

I gave up and  Turn off the key and try again 3X no luck, when and reset the evoall, re-flashed, NO luck neither .

Follow the troubleshoot, swap C3&C4 location {Can hi, low} , still the module did not program, can’t pass step 8A.

Also every time I tried programing the Evo with the RED connector plug-in, the ignition keep latched.

I am really stuck now, Any help is greatly appreciated. 

Also i forgot to mentioned, I have tried to reflash the module to a Stand Alone (3X lock) and the programing still didn't get pass step 8A.

Also the service number above has F2 which is now on. 

 

​This evo-for1 will be feeding the compustart CM5000. 

 

 

asked Feb 28, 2018 in Ford by David Nguyen3 (260 points)
edited Feb 28, 2018 by David Nguyen3

1 Answer

0 votes
del and revised the question.
answered Feb 28, 2018 by David Nguyen3 (260 points)
If you enter programming releasing only when BLUE led is on, turn ignition on, does the blue led flash ?
To help close the loop and thanks the Fortin team for their wonderful technical support. What I learned was the step 8 (a) when Blue & Red Led flashed 10X to the Flash of the blue LED was super quick, can’t really catch it in time if you were NOT paying attention. I found this out when I re-flashed the Evoall as a Standalone (3X lock starting) in order to test the programing portion. Once I have confirmed the programing was good, I re-flashed the Evoall once again and use it as a bypass along with the Compustar Cm 5000 for the range. All in all, everything works the way it should. Once again THANK YOU to the Fortin Team for all your help.
...