2014 Toyota Tundra EVO-ONE Bypass Programming Step 4

Question

I am installing a EVO-ONE on my 2014 Toyota Tundra. I followed the "Key bypass programming procedure" steps 1-3 went as instructed. When I perform Step 4 both red and blue lights stay on solid and do not flash at all. I have done a master reset but am not able to get step 4 to complete.

 

Any suggestions?

Answer 1

You need to press the programming on the module, not the one connected with a wire. The button is placed right next to the yellow loop.

Comments

Thank you for the quick response Mathieu. Just to clarify, I was not using the valet button. I got to step 4 by using the programming button.

---

Your EVOONE is not flashed to the appropriate firmware, you absolutly need to update the module with a flashlink updater and a computer.

---

Mathieu, Got the flashlink and updated firmware. All is good now.

Thank you for the help.