Questions & Answers

Spark 2017 key

0 votes

I have a 2017 Spark key.

I connected the Wire to Wire as per the instructions.

https://cdn02.fortin.ca/download/90461/EVO-ALL_IG_SAL_BI_CHEVROLET-SPARK_2016-2019_A_90461.pdf

When I press the key 3 times lock the switch will open but don't start and the light flashed 3 times red.

When running the engine and shutdown by using the key and pull out then  i press the lock 3 times the vehicle runing! and i can put the key in and drive, but if I press the brake the engine stop and I cannot start again from the remote (If i try the switch will open but will not try to start) I must use the key again to start and stop the engine and pull out to I can start again by using the lock button with someone below firmware version!.

Sometimes the engine starts and stop immediately.

I tried firmware version  70.46 & 70.41 & 70.42 & 70.43 & 70.44

I want to reset both units

SN: 001A07157086

SN: 001A07501809

asked 1 day ago in Chevrolet by MUSTAFA ADNAN (870 points)

1 Answer

0 votes
Hello,

Did you connect the lt.blue wire on the 20 pin connector the the lt.blue/black?

If not then please connect them and re test.

Best regards.
answered 3 hours ago by derek g (363,980 points)

A10/A20 alright connected to each other and connected with Gray/Black

What about D4/A9 Do I connect them together and connect them with D6

What about the firmware version? Should I go with 70.41?

 What about reset both units?

SN: 001A07157086

SN: 001A07501809

...