Questions & Answers

I installed an evo-one with 441 rf kit and can't get any response from valet button or antenna LED

0 votes
2004 GMC Yukon Denali.
asked 3 weeks ago in GMC by Tony Shade (160 points)

1 Answer

+1 vote
Hello,

What is the S/N to the module?

 

Best regards.
answered 3 weeks ago by derek g (342,840 points)
002B04 625747
commented 3 weeks ago by Tony Shade (160 points)

Please try the following:

- Flash the remote starter with firmware 0.99

- Plug in and power up the evo-one in the vehicle for 1 minute

- Re flash remote starter firmware 1.26

- Re attempt rf programming via the valet button

 

If it sitll does not work, disconnect the brake wire and see if you can enter programming

 

When you enter programing mode the red led underneath the yellow loop will turn on.

 

Best regards.

commented 3 weeks ago by derek g (342,840 points)
It does not list a 1.26 firmware.
commented 3 weeks ago by Tony Shade (160 points)
The recommended firmware is 70.18.
commented 3 weeks ago by Tony Shade (160 points)
remote starter, not bypass, In pro mode click on the tab that says remote starter.
commented 3 weeks ago by derek g (342,840 points)
Still nothing.
commented 3 weeks ago by Tony Shade (160 points)
Are you able to enter valet mode via the valet switch?

Ign on, 3x on valet switch, ign off.

The red led under the yellow loop will turn on solid when in valet mode.
commented 3 weeks ago by derek g (342,840 points)
Yes, and the antenna led came on as well.
commented 3 weeks ago by Tony Shade (160 points)
Now I can get as far as the antenna led coming on steady but not flashing with both methods. Horn signals work as well.
commented 3 weeks ago by Tony Shade (160 points)
It is working perfectly now. I had a bit of trouble with the second remote, but after a few tries it works as well. Thank you so very much!
commented 3 weeks ago by Tony Shade (160 points)
No problem, glad you got it going!
commented 3 weeks ago by derek g (342,840 points)

Related questions

...