Questions & Answers

Evo-All don't start the engine

0 votes
Hi, yestarday i had installed Evo-ALL with T-harness cabel NIST1 on Nissan Murano 2009 year.

When pressed three times Lock on OEM fob- on evo unit on each lock the blue led flashes. After that on PTS button goes to ACC and ON. And there  is no starting of the engine. And everything goes to OFF. The evo unit at the end flashes the red led 3 times.

This is the video:

https://streamable.com/kne5vs

On car display its show to press the break pedal.

And we tested it, If someone else is in the car and pressed the break and from outside  press LOCK-LOCK-LOCK and the engine is starting. The doors are locked and from outside can not unlock it. If break pedal is pressed again, the engine stops and everything  goes to off. Then i can unlock the car.

The firmware is the latest 72.52 and try 72.48 the same issue.

Can anyone help me!
asked Dec 5, 2022 in Nissan by Dobromir Dimitrov (450 points)
edited Dec 5, 2022 by Dobromir Dimitrov

1 Answer

+1 vote
 
Best answer
Hello,

 

Please use the RL1 connector on the t-harness and re try.

 

Best regards.
answered Dec 5, 2022 by derek g (324,940 points)
selected Dec 5, 2022 by Dobromir Dimitrov
Only change the RL2 to RL1 connector and try it remote starting  or need to repeat the programming pprocedure again?
Just change the connector, no need to re program the module.

It works smiley . The remote start works with lock-lock-lock!

But another issue. The car is locked and can not unlocked with buttons. Lock-lock-lock can not stop the engine! I unlocked it with phisycal key and when open the door engine stoped!

Try different unit options or?

Please Derek, can you help? If i bye an RF kit(for example RFK411) can it help me to stop the engine remotly. Now i can start the engine with 3xLOCK and can stop it only if i open the door wiht tha phisykal key or wait 3 min to stop by timer?
Yes, if the oem remote does not work once the engine is remote started you would need an rf kit. Ay fortin rf kit will work with the evo all. You will need to enable the rf section in the evo as well if that hasnt been done using the flash link updater along with using the RFA-2A adapter.

 

Compatible rf kits can be seen here: https://fortin.ca/en/technology/rf_kits.html
OK, thanks a lot Derek. I will bye RFK411
Have you done the connection at the BCM for the LOCK and UNLOCK wire? inserting them in the empty pin of the BCM connector?
Yes i had connected pins for LOCK and UNLOCK. If i start the car with 3xLOCK., when press the unlock button ot OEM remote or button on door, the the car sound it-Di-Di-Di and nothing happend. it is the same when starting car normaly from Push-to-start button and comes out of the car and try to lock it from OEM remote. Only can lock it from button on the door. i think tha car has some feature that not allowing to lock the car!!!
...