Questions & Answers

Evo-ALL - try reset but getting 3 solid LED lights

0 votes
Hello, I was getting the solid red light on my Evo-all. I decided to do a reset. I installed firmware 0.99 and while pressing programming button and connecting datalink from the car Instead of getting the solid red light I got all three solid lights. Can anyone tell me what does it mean and how do I get it to work ?

 

 

I'm trying to install remote start to 2020 Rav4 XLE premium with push start.
asked Dec 12, 2021 in FAQ by Francisco Roa (130 points)

1 Answer

+1 vote
If it's stuck on red, this normally means the original flash was corrupted, to fix this issue, follow the steps below:
 
1. Flash module to 0.99
2. Plug ONLY the connector that provides power and ground to the module.(black datalink for evo-all, 6 pin Main harness for Evo-1 in high current configuration.)
3. Once the 3 leds light up, disconnect from the vehicle.
4. Reconnect to the Flashlink Updater and reflash the required firmware for the vehicle.
5. Reprogram in the vehicle, following the installation guide.
answered Dec 14, 2021 by Jesus Monroy (63,860 points)
...