2009 S4 MANUAL TRANS, NO START AFTER 3X LOCK

Question

Hello,

I have a manual trans Audi s4 2009 keyport Evo One , i have installed the T-harness - yellow line from 6 pin to the clutch bypass (red/blk) in engine bay as per pics, Canbus High and Low installed correctly and the Pink from the 6 pin to the purple/ yellow  to convenient ignition out.

I have the module programmed as per intructions and no error. when connect all the plugs and lock the car then try 3x lock to RS nothing happens. I see the module flash with a blue led at every lock and unlock but no ignition.

Evo One S/N 002B04 013291

Thank you in advance!

Stu.

Answer 1

Sounds like you aren't setting ready mode. 

 

You need to enable option 33.2 in the remote starter settings then refer to choice 3 in this guide for ready mode procedure. https://fortin.ca/en/download/87611/87611.pdf

Comments

Thanks Derek,

Ive just set 33.2 and i have the car responding to the ready mode, but... when i remove the key then engine does keep running up untill i open the door then it stops, and not when i close it as the treadt mode instructions describes. It still wont respond to the 3x lock for the RS.

Thanks for the help.

 

Stu.

---

When you press lock on the OEM remote, does the blue led flash on the evo?

 

Also double check that option C1 & D6 are on in the bypass and option 38.2 is on in the remote starter as well.

 

Also turn off 37.2

---

Using the OEM key does flash the evo blue led, I have changed the push to start option to "On" as I had it off ,is that correct for the key port option S4? D6 was On. I set the car into ready mode the red and amber led light up at the same time and the engine is still running till I open the drivers door and then the engine switches off. After I get out and close the drivers door it locks the doors automatically (which it didnt do before the evo install ) and after I try the 3x lock the evo unit flashes blue for the first press then misses the second press and flashes for the 3rd press.

---

Slow down how fast you are pressing lock.

 

Also turn off 37.2. It's still on.

---

37.2 was the culprit! Thank you very much. Without your help it would have ended up in tears and frustration, and some broken stuff!!! Thanks again Derek, Stu.

---

Glad you got it going.

 

All the best.