Evo-One will not learn key or red stuck on after 10 flashes (2006 rav4 limited FWD)

Question

can not get the red led to turn off after the key has been programmed .I have used connection 1 and programming 1 of the guide for this vehicle.I have triple checked all my wirirng and all is good.

Does the rav4 need something special for the key.My key has a "G" molded into the plastic part close to the RF ID chip?

Am I missing something? Without the key programmed I can't test if the vehicle will start?

The vehicle does start normally, just not tte 3X lock to start?

I also checked to make sure all the correct parameters are loaded for this year of vehicle.

Any help Please, so fustrated :(

Answer 1

Your vehicle is NOT 3x lock compatible, you will need a seperate RFKIT to remote start the vehicle.

For programming, the module does not detect the data wires, make sure RX is pink and TX is green.

Comments

What rf kit do I need? I also have a evo-start module installed, will I need the rf kit to start the vehicle over the smartphone app also ? Or will the evo-start app work by itself and start the rav4. Wasn't sure, since I could not get the entire programming completed since the red led would not turn off after to 10x flashing after I thought it learned the key? It doesn't say anything about needing an rf kit on the fortin website, unless I completely missed it. What about if I was to install an evo-all instead, would that make things easier for me. Please let me know Thanks