Brake kill not working

Question

Evo-All, CHR5 T-Harness, Crimestopper RS7-G5, 2007 Jeep Patriot Limited (4x4) 2.4L w/ automatic transmission.

Remote start works, as does lock/unlock, from ALL REMOTES (2 factory key/remotes and Crimestoper remotes). The brake kill without the key in and turned is not working. I literally drove the vehicle around the block with NO keys even I the vehicle.

Also, key take-over not working. If remote started, and key put in and turned to run, 2-way remote still chirping and showing that the run time timer is still going.

Answer 1

try hooking up the evo brake output wire (black wire 20 pin connector) to the brake input wire of your remote starter then re test.

Comments

That black wire is a (+) positive, when brake is applied?

---

Yes that black wire on the 20 pin harness is a brake output. What's the service number on the module ?

When pressing the brake pedal, does the brake light on the back of the vehicle light up ? Could be a faulty brake switch in the vehicle....

---

#001A06 603012 The vehicle came back today and I tried the wires y'all suggested (black on Evo and purple on Crimestopper). Still didn't help. Tied the purple from Crimestpper to (+) brake, and now engine kill and takeover works. This didn't fix the issue, as I shouldn't have to tie into brake peddle. The program is like others I've done, but this time I had to upgrade the firmware. But still no help, even tried old firmware, but still no go.

---

Makes sense brake did not work...The option was turned off in the evo.

---

This is currently how you have it set up.