Toyota Camry Hybrid 2013 Push to Start Evo ALL - remout start dont work

Question

Good day.

Can you please tell me what could be the problem during installation, what am I doing wrong.

 

Fortin Evo ALL Date: 10/2019

 

Toyota Camry Hybrid 2013 Push to Start

 

I updated the firmware to 79.52, connected it to the car (wire to wire), flashed it, all according to the instructions. Then I close the car, I press on the standard key fob 3 to lock, nothing happens, the red light on the Evo All indicator blinks 4 times.

 I installed the firmware 79.41 and performed all the same actions, the result: the car unlocked the doors, then the dashboard lit up, then the doors closed. But the engine did not start. The EVO ALL Brick is lit red and yellow.

Answer 1

If ignition turns on but vehicle does not start up, check the steering lock connection.

Keep in mind car is a hybrid. Actual gas engine may not start. If the Ready light is on in the dash, then car is started.

 

Make sure you enabled option D4 in the settings and option D6

Comments

Hi

Thanks for the tip. I'll check. But the inscription does not show ready. I'll take a photo a little later