2014 Jeep JK Clutch bypass

Question

installing a push to start system with my 2014 jeep wrangler JK. I have managed to prove everything programmed well and was usable while the clutch was pushed in. The moment i released the clutch, my EVO-All displayed a RED LED and i had to reprogram for it to work. I suspect this is due to a clutch switch bypass that is required

Here are my questions

- I see a 5 pin relay that needs to be used but i also see a note that i can use the EVO-ALL relay?

- I'm also reading this relay will not allow cruise control. Is this true? If so, is there a way to bypass momentarily but keep the fortin programmed when bypass is not engaged? I would like to install a switch to disable the clutch bypass when the vehicle is being serviced or for use with cruise control.

Please help

Answer 1

You can not use the relay from the EVOALL for clutch bypass. You must wire the relay has shown in the vehicle wiring diagram http://www.wirecolor.com/en/vehicles/jeep_wrangler_-_standard-key_(2012-2018)/

Comments

Are you able to help confirm if this is what is causing my Evo All to show a Red LED once the clutch is released?

 

And for the clutch relay diagram, you're suggesting to use this one?

 

http://image-1.wirecolor.com/vehiclegroupimage/69231.jpg

---

You can not use EVOALL in standalone configuration on a manual transmission vehicle. What you are trying to do will not work. You need a seperate manual transmission compatible remote starter or an EVOONE.