2013 NISSAN JUKE STAND ALONE

Question

Hello. A question. In the past year I installed evo-all (stand alone) on the 2013 nissan juke PTS and everything was fine. Yesterday, too, I installed evo-all again at 2013 juke, but did not start without pressing the brake pedal. Two days of suffering. Then I noticed that the car did not start on the first pressing of the brake pedal and on the PTS. At the same time, only the ignition was opened, and on the second press it was started. And, without a brake, pressing only on pts, three times it was necessary to press to turn on the ignition. I had to add the relay in the brake line to the brake pedal. And, now + 12V is applied to the pedal after the ignition is turned on. Is there any solution to this issue?

Answer 1

Are you using a t-harness ?

If the vehicle does not remote start without pressing the brake, then the brake connection is probably wrong.

Comments

I used the circuit without t-harness. After installing the relay, everything became normal. The car itself was such that it was started after the second attempt  Fortin gave + 12V on the brake not at the time. And, I installed the relay so that it would give + 12V after opening the ignition.