ford fusion and guide 96151

Question

Hello. In manual # 96151, A1 wire is not connected. Without this, the module was not programmed. I connected it to the ignition switch (ON1). Leave it connected or take it off at the end? I installed standalone and the engine starts without opening the ignition. In the instrument panel it says that the battery in the key is discharged. I wonder if the engine is fully started? When the temperature rises, will the cooling fan turn on or not? I mean, there will be no need to apply + 12V to the ACC wire?

Answer 1

The guide you followed triggers the oem remote starter by ford.

Your heating is controlled through the IPC menu, you will be able to change it to heating on when remote start. If you did not find it there, that means you need to use IDS or forscan to turn that option on.

The ignition wire is not needed for this installation.

Comments

 But, without this(A1), the module was not programmed