Unable to program the module

Question

Hi

when I program On my Ford Fusion 2013 standard key and reach the last part where blue light flashes and ignition turns on by itself, the issue there is that the blue light keeps flashing and ignition turns on and stays on. When I turn the ignition off manually by putting key in ignition and tries to start the car by pressing 3X lock, nothing happens. What could be the issue ? Help

Answer 1

if i can ask you which wires did you connect and to where, i bought an evo all for my 2013 ford fusion and cant get the unit to turn on when i connect to the car. i connected the blue, light blue and yellow wire but when i connect the four pin to the unit no lights turn on. i flashed the unit to 71.49 and connected the two grey wires to the obd can high and can low. any ideas would be appreciated.

Answer 2

Gonna need a but more details to help you:

-Service number or S/N to the module.

-Parts being used in the installation.

Comments

Service number is 001A06819678

parts used are

module

t harness

can harness

---

The module is not flashed properly.

 

What t-harness are using?

---

It is THAR-FORD2, REV 1

---

You need to use firmware 71.49.

2 keys required for programming as well as flash link updater.

---

I have flashlink !

---

I have 4.01 firmware loaded right now

---

You need to use firmware 71.49.

2 keys required for programming.

 

https://fortin.ca/download/59421/evo-all_ig_tsa_bi_for2-fusion_2014-2016_b_59421.pdf