Questions & Answers

Does EVO-ALL need Flashed after programing?

+1 vote

 votes

 

Hi, I have an EVO-ALL service #001A06278574 I'm installing in a 2012 Suzuki Kizashi. with an Audiovov Prestige APS901C Remote Starter. The Blue light is blinking slow on the Fortin. The car will crank over with the remote start but will not start. The dash displays accessory not ignition on when it is trying to start. The Fortin has version 6 hardware and 4.18 firmware. does this meet the requirements that I need for this car or does it need flashed after I program it? The dealer flashed the Fortin for the car when I purchased it but when I downloaded the installation instructions it says to Flash it after I program it. Any Help would be appreciated.

Thanks,

Mike

 

posté Jan 6, 2014 dans la catégorie Suzuki par Mike Beirlair (180 points)

2 Réponses

0 votes
Hi Mike,

 

According to install guide No. 6691, 4.10 minimum is required for that Vehicle, so 4.18 should work great.

 

On Step 10 of programming procedure we ask you to plug the Evo-All on the computer to do the DCRYPTOR process wich is required to clone your key. So you need a FLASH-LINK-2 and a computer with a working internet connection to finalize your install.

 

Have a nice Day
répondu Jan 6, 2014 par Charles Beauchamp (9,020 points)
0 votes
After you have done all the data aquisition (programming) in the vehicle, you will need to run the dcryptor program with the flash link updater 2 in order for the EVO ALL to learn the key. This is required for the module to learn the transponder. If you can not run the dcryptor you can also use a keybox or do a key wrap with the existing remote keyfob. The firmware on your module is up to date and should work in your vehicle provided you run the dcryptor.
répondu Jan 6, 2014 par Charles Beauchamp (8,290 points)
...