Module receives command but no crank

Question

Hi,I have 2016 Subaru Legacy with Evo One with T-Harness,,when trying to remote start dash lights comes on but Car does not crank,parking lights 3x flash before and 4xflash after remote start attempt.

Also I checked voltage white and yellow wires,

1)during remote starting voltage is detected on white wire but NOT on yellow at connector plugged in the ignition,

2)also on the connector(T-harness side) that is plug on the oem ignition connector also has no voltage on yellow wire but has voltage on white when attempting to remote start,but on the module 6pin connector the yellow wire and white wire both have voltage.

when using key to start both yellow and white wire has voltage on all side of connectors.

Answer 1

Looks like the t-harness is defective or damaged.

Comments

Hi, i went ahead remove  the T-HARNESS and hard wire it instead,and everthing works now,,not sure how or what made the T-HARNESS go bad.

Anyways when remote started the red and yellow led on module suppose to be on right?

 thanks