Questions & Answers

Evo All does not successfully program

0 votes
Hi, I'm having trouble programming the Evo-All. I've checked on the FAQs and made sure I have a good connection to the ignition. Can you provide any troubleshooting why it will not program. I've managed to get to the step where I hold the program button and insert the data-link. I release when the red and the blue are illuminated and I then proceed to connect all remaining connectors. Connected the 12 pin and then the 2 adjacent 5 and 6 pin connectors. I then proceed to press the program button 2x however no change occurs. This is where I'm stuck.

 

Additional Info: 2012 Camry G-Key, CrimeStopper RS4-G5

 

Also it seems that the auto light does not turn off.
posté Dec 5, 2016 dans la catégorie Toyota par Zack Khan (130 points)

1 Réponse

0 votes
Your module must be updated to the latest firmware.
répondu Dec 5, 2016 par Zack Khan (85,210 points)
I am having the same issue. My remote start also came with the crime stopper remote start as well as the evo-all. My system came as a hard wired system and all the wires were hooked up and triple checked as per the instructions. My firmware should be up to date. I have noticed when I plug in the wired indicator light, the light is illuminated and will stay illuminated constantly. It wil allow me to program the CAN HI and CAN LOW. When i try to program the keys the red light stays light and the yellow light also comes on and stays on too.

I have a 2010 Ford F-150. My kit came as a hard wired kit with the EVO-ALL and Crimestopper
...