rf kits can not program

Question

i have installed an axone in a 2014 rav 4 my oem remote works with the 3x lock remote start nut i can not unlock the doors once the car has been remote started. i have tried to install an rf kit but can not get the remotes to program. the rf kit i have is fortin rf442w. can some one help me program my remotes?

Answer 1

If you cannont unlock the doors when the car is running, the doorlock data wire is not correctly connected and the main body ecu.

To program the rf442w remote turn ignition on, press and hold programming button (not the one on the module, the one that is connected to the axone) until the led next to the yellow loop start to flash than release.

Press the programming button 5 times. Press once on the foot brake. Press [-] and then lock on the remote. Turn ignition off.

 

A quick call at tech support during office hours and somebody will guide you into the programming.

Comments

I double checked the door data wire and it is connectors to the right wire on the car the light bile wire. As for the rf kit I tried to connect them following your instructions and the light on the axeone did not blink no matter how long I held down the programming button which connects to the module. What could be causing my issues ?

---

if you cannot get the red led on the side of the unit to flash to get into the programming mode, it could be as simple as the evo unit being in "locked/armed" state.

 

Please cycle in and out of valet, by turning the key to ignition and pressing 3 times on the valet switch, try to get the led on the side of the unit where the yellow wire loop is to go solid, once it's solid, repeat steps with key and valet switch to shut off the led, and try to program

---

thank you very much, u saved my day

---

this exactly what happened with me thank u again