Questions & Answers

EVO-ONE will not remote start on 2015 Nissan Armada

0 votes
Using EVO-ONE bypass firmware version 72.19, t harness and RF642W 2-way remotes on 2015 Nissan Armada with Intelligent Key.

Remotes will lock/unlock and communicate with vehicle, but will not remote start vehicle. Noted during key programming that module does not operate park lights, so no park light flash code to use. Module programming, key programming, and remote programming completed, but vehicle will not start with remotes. Will make two attempts to start (can tell by driver's foot light operating), but dash lights do not come on and vehicle does not start. Occasionally, vehicle alarm will sound after first attempt (of two) to start. Module programming LED will flash after failure to remote start. Does not appear to be a flash code. While attempting to start, various module LEDs will flash on and off briefly. 2 way communication works properly (remote beeps to indicate remote start failure), and lock/unlock function of remote work normally. Query of vehicle status works normally. All wiring double checked using guide #17763. Ignition diode indicated in EVO-ONE box (rev. 20150225) installed.
asked Aug 26, 2015 in Nissan by Valeria Grundy (130 points)

1 Answer

0 votes

~Ignition diode indicated in EVO-ONE box (rev. 20150225) installed

 

The guide does not ask to put diode on ignition. the two diodes goes on key sense and tumbler sense.

 

This can take some time to diagnose... a quick call to tech support will solve your problem.

 

answered Aug 27, 2015 by Valeria Grundy (85,210 points)

Can you please go to http://www.fortin.ca

Type in 17763 in the "quick vehicle finder"  box on the top left part of the Fortin homepage.

Check revision date on guide, it should read, REV.:20150527

Compare this guide to the one you used (rev 20150225)

As Mathieu pointed out before, there should only be 2 diodes, hooked up to the wires on the tumbles switch connector.

 

Thank you,

 

Also, could you tell us where you got this Evo-One from? And do you have a Flashlink-2 updater?
The cause was that extra ignition diode. It was not in the guide, but in an insert that came with the EVO-ONE. The insert said to install the diode if using the RF kit I was using. I emailed a picture of the insert in to the tech support call center. Removed the diode and now it's starting. Park lights still don't work, but it turns out they have to be wired in with a relay, even though this is not in the guide.
Could you please tell us who and where you got this Evo-One from? That technical insert was not from us and would like to know who is adding it so we can minimize issues like this.

We did get your email, but since we did not have any other information aside from the photo, we did not know to what the photo was referring to.

As for the parking lights,  if you look at the supported vehicle functions list, parking lights is not in that list since we cannot control that function through data.

Thank you,
...