2008 A4 can not program remote

Question

EVO-ONE-912

I wired everything using guide #85631

Flashed the module with the Flash Link Manager

Programed the module to the car... blue light flashing

Cycle key on-off-on, LED on antenna solid blue, push brake pedal 4 times and nothing happens

Answer 1

If the brake is not being detected on CAN-BUs, you will have to wire the brake signal.  Black wire from connector A to the vehicle brake wire

 

Vehicle brake signal:

red/black wire in a green 17 pin connector, pin 6

Comments

Thank you, that worked. do you happen to know the trigger wires for the hand brake and park lights?

---

(-) Park brake = brown/white, Comfort Module in front of driver seat under carpet, blk 12 pin connector, pin 2

(+) parking lights = gray wire, headlight switch, black 17 pin connector, pin 14
May have to interrupt the headlight switch OFF wire for the lights to work. It is purple at the headlight switch, black 17 pin connector, pin 3.

---

Thank you, that all works as it should now. Is there a wire to trigger the clutch switch? Also it is not recognizing the key under the dash, I wrapped the white/blue wire around the key 6 times and connected it to the white/green wire as shown in the guide. I have installed many remote starts but this is my first Fortin as well as manual transmission, if there are any other connections or anything else that I would need to program on the FlashLink Manager that you can think of please let me know. Door locks work and it will remote start with the clutch pushed in and key in the ignition