Stand Alone Mode.

Question

I received this EVO ALL for a gift. after buying the t harness for my 2011 chevy cruze and tearing the dash apart to get to the ignition switch, I started the programming . I cannot get this to get past the 5 seconds or less part of the programming. After reading up on this , I noticed that I have to buy a Flash Link and set this unit to stand alone , So, more stuff I have to buy?? This is really difficult and I don't reccomend this EVO ALL unit to anyone . the instructions are difficullt to understand. I already bought a T harness and was thinking of just selling all of this and taking my car somewhere to have a starter installed.

anyone want to buy this EVO ALL Firmware 4.18 and a THAR-GM1 harness? CHEAP.

Answer 1

The T-harness that they sent you is not the right one for the firmware that you currently have on you EVO.

The THAR-GM1 is only compatible with firmwares 4.06 or less.

The THAR-GM1v2 is the one that the eBay guy should of sent out. This is properly indicated on our website to use the THAR-GM1v2. http://ifar.ca/en/vehicles/chevrolet/cruze/2012/

---

 

Personally, i would contact the eBay guy and get the right stuff for your car. Also make sure that he updates the unit for you and also activates the Stand Alone feature.
 

---

CHEAP

I don't think so.