Questions & Answers

Ingition comes on, but engine does not crank

0 votes
Hi,

I have  a 2005 Chrysler 300 C and have fitted an Evo-All in stand alone mode.   

All programming seems to have worked ok (atleast the unit responded as per the documentation.  And i have enabled the stater option ( i have checked a couple of times on the unit).

When i click the key remote 3 times,  the doors lock-unlock-lock,  the ignition and lights turn on.   but the engine does not crank.   

The units lights go from blue, and then end up at red.

I assume the immobiliser is kicking in to prevent the car starting ?   do you have any suggestions?

The car still starts fine with a key.

Thanks
asked Dec 19, 2016 in Chrysler by Russell Cooper (130 points)

2 Answers

0 votes
Did you connect the mux and starter wire and the ignition barrel ?
answered Dec 20, 2016 by Russell Cooper (85,210 points)
I did - the unit seemed to program ok, would that also verify the connections are good?
programs on CAN-BUS, not on the MUX.

The MUX and MUX Ground are almost the same color. I would check that along with making sure a signal makes it to the Starter wire
0 votes
do you have lock/unlock/lock option selected or lock/lock/lock on the evo?
answered Dec 20, 2016 by Ultra Auto Sound (4,920 points)
...