2019 ford f150 won't start

Question

Hi, installed evo all with t harness stand alone and it programmed fine, but it won't start the blue light on evo all blinks blue with 1st and 2nd press but not on 3rd press. Is there a way to activate the evo all to make sure it's programmed right, is there a wire i can ground to activate it? Does option b2 need to be on to add evo all single button one way rf kit ? Does protocol have to be set to fortin or is it automatically set to fortin? SN 001A07011080

Answer 1

"is there a wire i can ground to activate it?"

 

Yes, yellow/black wire on the 20 pin connector. 

 

"Does option b2 need to be on to add evo all single button one way rf kit ?"

 

- No

 

3x lock is not working because currently option D 1.10 is not enabled. Please turn this option ON and re test. 

Comments

Thank you one more question, i did the programming to the truck twice when it didn't work, i connected the 4 pin holding down the button again did that affect the evo all? Do i have to reset it ?

---

no should be fine.